KONICA MINOLTA MC7450 PPD DRIVER

Cancel Click to exit the Properties dialog box without saving any changes made. This setting is used to link a tray setting specified from a third-party printer driver with trays on this printer. If the problem persists, contact your local vendor or authorized service provider. Note Decreased print quality may result if the surface of the image transfer belt or the transfer roller is touched. When this menu item is selected, the printer is automatically restarted. OK Click to exit the Properties dialog box, saving any changes made.

Uploader: Vugami
Date Added: 16 May 2004
File Size: 19.65 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 67305
Price: Free* [*Free Regsitration Required]

DriverHive – device driver updater software

Output Monica All printed media is output to the face-down output tray on top of the printer. Push the imaging unit to securely insert it so that it snaps into place.

Holding a stack of approximately sheets at a time, fan the stack to prevent static buildup before inserting it in a tray. Introduction Solving other problems Solving problems with printing quality Status, error, and service messages Printing a Configuration Page Print a configuration kinica to verify the printer is printing correctly, or to check the printer configuration.

Konica Minolta magicolor II grafx : Owner’s manual

Tray 2 Loading Media Pull out Tray 2. Media Rollers The accumulation of paper dust and other debris on konic media rollers can cause media-feeding problems.

Are you in Europe? Do not load paper above the mark. To save the current settings, specify the desired settings, and then click Add. Lower Feeder Unit You can install up to three optional lower feeder units Trays 3, 4 and 5. The magicolor configuration menu accessible from the control panel is structured as shown below. If multiple lower feeder units have been installed, remove the cover over the relay harness connection slot for any lower feeder unit other than that on the bottom, and remove the mounting tape on the relay harness.

  DVD GCC-4247N DRIVER

Continue these steps until all four digits of the password are specified. Please select another Change Location. Please contact the Local Authority for appropriate disposal instructions.

Konica Minolta

Pull up the locking tab of the empty toner cartridge to unlock it. Adobe shall not be liable for loss or damage arising out of this Agreement or from the distribution or use of the Software or any other materials.

Page 49 Press the Up and Down keys to increase or decrease the second digit of the password. Lateral lines or bands appear on image.

Multifunctional Printers

Doing so may damage the mc74550 and cause the print quality to deteriorate. Replacing a Imaging Unit When replacing a imaging unit, refer to the following table. Page – Clearing a Media Misfeed from the Fuser A document is printed Print the overlay file using a suitable with an overlay file printer driver. The Overlay Tab allows you to Replace it with a new imaging unit.

  COPYSTAR 420I DRIVER DOWNLOAD

Page 27 Uninstalling the Windows Printer Driver This section describes how to uninstall the printer driver if necessary. Mc740, Error, and Service Messages Status, error, and konlca messages are displayed in the control panel message window.

DO NOT use thick stock that is Mixed with any other media in Tray 1 as this will cause printer misfeed- ing Envelopes Print on the front address side only. This setting is used to link a tray setting specified from a third-party printer driver with trays on this printer. Printing on Envelopes 1 Pull the lever, and then open the right side cover.

If it is damaged, replace it. If this is the case, continue with the next step. Page 11 12 13 While supporting the imaging unit from the bottom, insert it into the printer. It takes more time to print on special media. Page Media Rollers The accumulation of paper dust and other debris on the media rollers can cause media-feeding problems. Page Note Decreased print quality may result if the surface of the konca transfer belt or the transfer roller is touched.